Blomberg KI1151 Uživatelský manuál Strana 15

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 20
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 14
Changing the light bulb
Warning! There is a risk of electric shocks! Before changing the light bulb, switch off the appliance and
unplug it, or pull the fuse or the circuit breaker.
Light bulb data: 220-240 V, max. 15 W
1. To switch off the appliance, turn the temperature regulator to position "0".
2. Unplug the mains plug.
3. To change the light bulb, undo the cross head screw and remove
the light bulb cover.
4. Change the defective light bulb.
5. Refit the light bulb cover and the cross head screw.
6. Put the refrigerator back into operation.
31
Symptom Possible Cause Remedy
The compressor does not start immedi-
ately after changing the temperature
setting.
This normal, no error has occurred.
Water on the floor or on storage shelves. Water drain hole is blocked. See the “Cleaning and Care” section.
The compressor starts after a period of
time.
Customer Service
If you cannot find the remedy for a malfunction in these operating instructions, please contact your
dealer or our customer service department. Addresses and telephone numbers are listed in the accom-
panying booklet "Guarantee Conditions/Customer Service Locations".
Selective ordering of replacement parts can save unnecessary travel and costs. For this reason always
provide the following appliance information:
• Model Name
• Model Number (PNC)
• Serial Number (S-No.)
This information can be found on the serial plate in the interior at the left of the appliance. We recom-
mend that you enter this information here, so that it is handy if needed.
Note: The customer bears the costs of unjustified customer service calls even during the guarantee peri-
od.
Noises during Operation
The following noises are characteristic of refrigeration appliances:
Clicks
Whenever the compressor switches on or off, a click can be heard.
Humming
As soon as the compressor is in operation, you can hear it humming.
Bubbling/Splashing
When refrigerant flows into thin tubes, you can hear bubbling or splashing noises. Even after the com-
pressor has been switched off, this noise can be heard for a short time.
Zobrazit stránku 14
1 2 ... 10 11 12 13 14 15 16 17 18 19 20

Komentáře k této Příručce

Žádné komentáře